Initial release

README.md

@@ -1,3 +1,26 @@
 # Yanmar
 
-Some 3D designs for the Yanmar engines, like ignition key and stop knob.
+Some 3D designs for the Yanmar engines and saildrives, like ignition key and stop knob, and shim for the saildrive.
+
+## Ignition Key
+
+The metal ignition keys from my 3JH3E engines were corroded and were always reacting with the metal of the lock, regularly binding.
+I always keep the key in the ignition so that sailors can rescue my boat in case it starts dragging its anchor, so there is plenty of time to corrode.
+
+I printed a new set of keys from PAHT-CF. This is carbon reinforced nylon. I tried printing first with ASA but that turned out to be too weak.
+
+Be careful here: If the key breaks at an unfortunate moment loss of property or life can occur!
+
+## Stop knob
+
+My engine installation has the mechanical stop knobs that operate via a bowden cable. The T-handles were looking ugly and always mis aligned.
+I designed nice round knobs that also cover the (often rusty) nut underneath. I printed them with ASA because they are always outside in rain, spray, and strong UV.
+To attach them, it might help if you use a thread cutter first, then use a grip spanner to prevent the stud from turning.
+
+## SD50 saildrive shim
+
+The prop shaft seals of my saildrives started to wear out more quickly. Problem is that the seals worn a groove in the prop shaft, which is a common problem.
+If you put this shim in the seal housing first, the seals will shift up a little and start working on a new part of the shaft.
+This is a much easier and cheaper solution than buying a new shaft, using a sleeve, or have the shafts welded up and machined afterwards.
+I printed these with PETG, which is oil and water resistant. Once installed, there is no force acting on them so they are strong enough.
+